[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index] [Xen-API] XCP 1.6 build 61809c bonding issue - lost connection on ProLiant BL465c G7 with Emulex NC551i dual-port 10 Gb CNA and HP VC Flex-10 Enet Module
Hello, I use this hardware configuration:ProLiant BL465c G7 with embedded Emulex NC551i dual-port 10 Gb Converged Network Adapter Two HP VirtualConnect Flex-10 Enet Module Cisco C2960GAll firmwares are in current versions. Emulex NC551i using FW version 4.1.450.7 corresponding with be2net Emulex OneConnect 10Gbps NIC Driver 4.1.450.7 in XCP kernel. I set two NICs to bond0:eth0 is in the network on the first HP VC Flex-10 with uplink thru port X3 connected to C2960G eth1 is in the network on the second HP VC Flex-10 with uplink thru port X3 connected to C2960G This is easiest setup for redundant connections over two HP VC Flex-10 verified as correct by HP support without any hardware problems. After switching off the first HP VC Flex-10, all traffic is automatically send thru second HP VC Flex-10 - this is OK. After switching on the first HP VC Flex-10, communication is interrupted forever - this is BAD. The problem can be solved only after reboot XCP. I'm creating bond by using this command: xe bond-create network-uuid=uuid_bond_network pif-uuids=uuid_eth0,uuid_eth1 States of NIC correspond with output of: ovs-appctl bond/show bond0 I would appreciate any advice. Thank you Jan Martinu _______________________________________________ Xen-api mailing list Xen-api@xxxxxxxxxxxxx http://lists.xen.org/cgi-bin/mailman/listinfo/xen-api
|
Lists.xenproject.org is hosted with RackSpace, monitoring our |