| Hi Lars,
I have been thinking that due to a busy time is coming (you know people's holidays in department, mine ones :) and so…) I'll be perhaps a little more busy than I'm normally, probably… So perhaps it would be nice to write a blog post or some kind of information in order that people to be able to start using FreeBSD with XenCloud…. and If FreeBSD people has no problem with that I would like to prepare a port for FreeBSD in order to have a simpler way to implement it but I will start writing it on mid or going to the end of September. So mean while, would be nice to exist some kind of documentation.
Would you like me to write some doc and then email you with it for example??.
Tell me if I can help some way :) . Best regards,
El 07/06/2012, a las 09:02, Egoitz Aurrekoetxea Aurre escribió: Good morning Lars,
Yes, may be :) I'm looking for creating a FreeBSD port which would simplify the process a little… but if the port is not accepted in FreeBSD ports or exists any kind of problem… I'll write a post or whatever sure :)
Have a nice day mate, Best regards
El 06/06/2012, a las 17:38, Lars Kurth escribió:
Egoitz,
is this worth creating a page on the wiki or maybe even a guest blog
post on blog.xen.org?
Regards
Lars
On 04/06/2012 12:18, Egoitz Aurrekoetxea Aurre wrote:
Good morning,
I have wrote previous mails about this topic from egoitz@xxxxxxxxxxxxx
address (I'm going to use this one in the future for this
mailing list). I have been working on adapting XenServerTools
for working with FreeBSD, and I'm proud to say here is the
result :) . It's working and although it's in testing phase it
seem's to work pretty nice :). I can suspend, move, use
ballooning, display ip, disk bandwitdth and so… from XenCenter.
So, I would like to share it from this mail, and basically know
if it works nice for you too :) ; apart from this, if Citrix
people does see any kind of problem with the code I would be
very thankful too if they notify me in order to solve it. It has
tested with FreeBSD 9.0 RELEASE, xen-tools-4.0.1 (port) and XCP
1.1.0-50674c. I think this could be too, a good starting point
for supporting FreeBSD in XenCloudPlatform :) (we can help
happily!!).
The requirements for getting this working are basically :
- Run FreeBSD 9.0-RELEASE 64 bit HVM Kernel (although should
work too with 8.2/8.3-RELEASE HVM Kernel and 64 bit too).
- Xentools port.
- And you should later extract the tar and copy the files to
the corresponding path on the disk.
After that just… '/usr/local/etc/rc.d/xe-daemon.sh start' and
enjoy it :) .
Let me know you're opinions.
Regards,
_______________________________________________
Xen-api mailing list
Xen-api@xxxxxxxxxxxxx
http://lists.xen.org/cgi-bin/mailman/listinfo/xen-api
Xen-api mailing list
Xen-api@xxxxxxxxxxxxx
http://lists.xen.org/cgi-bin/mailman/listinfo/xen-api
|
