Re: [Xen-API] openvswitch problem with XCP 1.0 RC3

[Todd Deshane <todd.deshane@xxxxxxx>]

On Fri, Feb 25, 2011 at 11:31 AM, Adrian Costin <adrian@xxxxxxxxxxx> wrote:
> Hi,
>
> No.
>
> NIC 0 with Network 0 is management interface
>
> Vlan99 is created using NIC1 and is assigned to the VPS.
>

Just in case that this is a local problem to you. Can you provide NIC
information, xapi log, and any other relevant information that could
try to explain the differences in both the Open vSwitch case and the
bridge case?

Thanks,
Todd

> Best regards,
> Adrian Costin
>
> -----Original Message-----
> From: deshantm@xxxxxxxxx [mailto:deshantm@xxxxxxxxx] On Behalf Of Todd Deshane
> Sent: Friday, February 25, 2011 6:31 PM
> To: Adrian Costin
> Cc: xen-api@xxxxxxxxxxxxxxxxxxx
> Subject: Re: [Xen-API] openvswitch problem with XCP 1.0 RC3
>
> On Fri, Feb 25, 2011 at 11:23 AM, Adrian Costin <adrian@xxxxxxxxxxx> wrote:
>> Hi,
>>
>>
>>
>> When using the openvswitch backend (which is the default) on XCP 1.0
>> RC3 network traffic for VLANs doesn't reach the virtual machine.
>>
>> Switching to bridge works without problems.
>>
>>
>>
>> Can somebody test this and confirm?
>
> Are you running into trying to do VLAN on the management interface (not yet 
> supported by XenServer/XCP as far as I know)
>
> See: 
> http://xen.markmail.org/search/?q=vlan+xcp+xenserver#query:vlan%20xcp%20xenserver+page:1+mid:7aujsddinvrlrjpy+state:results
>

_______________________________________________
xen-api mailing list
xen-api@xxxxxxxxxxxxxxxxxxx
http://lists.xensource.com/mailman/listinfo/xen-api