[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index] Re: [Xen-users] [XCP] XCP network and VLAN by Open vSwitch
On Wed, Jun 15, 2011 at 6:13 AM, Wei-Chih Chen (éåå) <wcchen.tw@xxxxxxxxx> wrote: > Hello Everyone, > > I am new with XCP. > I've setup several hosts with XCP 1.0 and manage it through XenCenter and > command console. > Each host has two NICs, one (xenbr0) connected to a physical switch for > Internet (said sw1), the other (xenbr3) connected to a physical switch for > internal network (said sw2). > > I am trying to setup VMs and VLANs on xenbr3. > I created a virtual bridge by "ovs-vsctl add-br brvlan2 xenbr3 2" > Then add a port (portvlan2) to brvlan2: > ÂÂÂÂ ovs-vsctl add-port brvlan2 portvlan2 tag=2 > ÂÂÂÂ ifconfig vlan2 192.168.33.200 > Now the problem is that I do know how to attach portvlan2 to VM. > Could someone give me simple steps to setup VLANs using Open vSwitch and > attach them to VMs? > > Moreover, the newly created bridges are not shown in XenCenter. > If I use xe network-create, the newly created network can be shown in > XenCenter. > Is this because XenCenter uses xe command and does NOT support to show Open > vSwitch? > The question I wonder most is what is the difference to configure XCP > network using xe and ovs- commands? > You are going to want to use the xe commands related to networking. See http://docs.vmd.citrix.com/XenServer/5.6.0fp1/1.0/en_gb/reference.html#networking-concepts Hope that helps. Thanks, Todd > Thanks a lot. :) > > Regards, > > Wayne > > > _______________________________________________ > Xen-users mailing list > Xen-users@xxxxxxxxxxxxxxxxxxx > http://lists.xensource.com/xen-users > -- Todd Deshane http://www.linkedin.com/in/deshantm http://www.xen.org/products/cloudxen.html http://runningxen.com/ _______________________________________________ Xen-users mailing list Xen-users@xxxxxxxxxxxxxxxxxxx http://lists.xensource.com/xen-users
|
Lists.xenproject.org is hosted with RackSpace, monitoring our |