Re: [Xen-devel] XCI: can we get to the demo state?

[Vincent Hanquez <vincent.hanquez@xxxxxxxxxxxxx>]

Phung Te Ha wrote:
> Hello XCI developers,
>
> I have a HP6930, downloaded xenclient from the git. And by following the 
> instruction in HOWTO, I could get xenclient boot up fine. I try then to start a 
> guest using xenvm.readme as template and nothing shows on the screen for the 
> guest, although xenops shows 2 doms running.
>
> Can you point me to how to start a guest. And also, is the tree downloaded from 
> git enough to arrive to what was shown in the demo video:
>
> http://www.citrix.com/tv/#video/423
>
> Thank you.
>
> Phung-Te

Hi Phung-Te,

The demo contains few bytes from citrix that are not available, however 
you can definitely have the graphics of your VM if you have VT-d 
available and enabled. At this point you just need to set at the end of 
your xenvm config:

pci = 0,bind,PCIBUSID_OF_YOUR_GRAPHIC_CARD

usually with an intel card this end up beeing:

pci = 0,bind,0000:00:02.0

--
Vincent

_______________________________________________
Xen-devel mailing list
Xen-devel@xxxxxxxxxxxxxxxxxxx
http://lists.xensource.com/xen-devel