[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]
Re: [Xen-devel] /etc/xc/defaults question..
The vbd_list contains a list of mappings of the form:
('real device name [as seen by dom0]',
'target device name [what the new domain sees the device as]',
The 'w' (writeable) permission implicitly also allows read access. The real
device name is specified as 'phy:devname' for a physical disk or partition, or
as 'vd:identifier' for a Xen 'virtual disk'.
As you know, you can use this list of mappings to selectively grant a new
domain access to certain disk resources. You should never allow two domains
to simultaneously have write access to any disk area - normal disk filesystems
aren't designed to cope with multiple-writer access, so it will cause severe
corruption. Linux also gets confused if a filesystem that's read-only by one
domain is written to by another, so single writer, multiple reader should also
be avoided (although it won't cause corruption).
It is perfectly safe to have two domains have read-only access to a
filesystem, however - this can be useful to avoid duplicating data).
Here's a concrete example of VBDs, where I'm configuring my system so I can
start a second domain:
Suppose my machine has the following real partitions (as viewed from dom0, or
booting with a normal Linux kernel):
/dev/hda1 : DOM0's / filesystem (the one you boot off)
/dev/hda2 : DOM0's /usr filesystem
/dev/hda3 : DOM0's swap partition
/dev/hda5 : a secondary / filesystem for use by a second domain
/dev/hda6 : a swap partition for the second domain to use
The new domain I'm going to start must have a separate / partition since it
will have different information in it. It will want write access to this
partition. It will also need a different swap partition to DOM0 because the
two domains will be swapping out different data.
I might, however, want to share the contents of /usr, since they'll be the
same for both domains. This would have to be read-only for both DOM0 and my
second domain, otherwise Linux will get confused.
* DOM0's fstab should specify /usr as read only.
For this example, I want the second domain to think its / filesystem is on
/dev/sda1, its swap is on /dev/sda2 and its /usr is on /dev/sda3.
* vbd_list = [('phy:hda5','sda1','w'), ('phy:hda6','sda2','w'),
This setups up the appropriate disk translations so that the second domain
will get this view of the disks.
* the other domain's fstab should match these details, i.e. / on /dev/sda1,
swap on /dev/sda2, /usr read only on /dev/sda3
The standard xc_dom_create.py does some sanity checking to try to avoid
dangerous sharing. If you get a VBD sharing error, then you should check
that, for instance, none of the second domain's filesystems are mounted in
DOM0 and that the VBD mappings do not allow incorrect sharing.
This should get you going. There's a more detailed discussion of this (and
some more advanced stuff about Virtual Disks) in the VBD-HOWTO.txt document,
which you should take a look at). You could alternatively use NFS-root to
boot the second domain.
This SF.Net email is sponsored by: IBM Linux Tutorials
Free Linux tutorial presented by Daniel Robbins, President and CEO of
GenToo technologies. Learn everything from fundamentals to system
Xen-devel mailing list