Re: [XenARM] Is there a new document about how to install xen on arm?

[Krishna Pavan <post4pavan@xxxxxxxxx>]

Hi Xen-ARM, zhangliuhang,

the source code xen-arm-opensource-20110714.tar.bz2 has got some error, WRT, xen-syms, according to me, which has been fixed by jaeminryu, you should probably
clone his GIT Repo.

it should generate a file name xen-bin,
If you want xen-bin from that source code, Do a make in <source_dir>/arch/arm

I want to know whether there is a new document match the new source codeâ

Â

The Guide is for different source code and is for i.MX21 and not other processor(s).
Â

2.ÂÂÂÂÂÂ I had to change to the old code. It works good and generate a file named xen-bin. But when I try to deploy it to the target platform I met another trouble.

Because, you have used a code which is designed for another board with ARMv5 architecture.

My platform is trim-slice, as we know it use U-boot as boot loader, could you give me some advice about what I should do next?

Check for a suitable code from this link HERE---->JMRYU77_REPO.
Â

--

â Regards :: Krishna Pavan â

_______________________________________________
Xen-arm mailing list
Xen-arm@xxxxxxxxxxxxx
http://lists.xen.org/cgi-bin/mailman/listinfo/xen-arm